Printable plank plan

Shortest end piece

Calculating…

—

A complete row sequence, checked against your product limits.

Planks run left → right. Row 1 is at the top. Hatching marks cuts. Room dimensions include the gap.

Inspect a row

Set-out and ordering assumptions

Measure the actual covering dimensions, excluding protruding locking tongues. Keep the factory locking edges at internal joints; cut ends and ripped edges face walls. Cut on the waste side of the mark. No offcut reuse is credited.

Row-by-row laying order

Start every row at the left wall, after the expansion gap. Lengths are listed left to right; a repeated full plank is written as count × length. Dimensions are rounded to 1 mm or 1/16 inch; verify final fits on site.

Row	Width	Piece lengths, left → right	Pieces

Fresh stock and grouped cuts

Every installed piece uses its own fresh stock plank. Piece 3.2 is row 3, position 2, and comes from stock plank 3.2. Grouped cuts share rounded dimensions and the same factory-edge orientation.

The dashed outline is the whole plank; keep the hatched part. Heavy lines are cuts. Measure the kept length from its factory end and the kept width from its factory long edge.

One rectangular room, one product, parallel courses. This plan checks the entered dimensions and three size limits. It does not approve subfloor conditions, room-size limits, transitions, locking direction or appearance for your product. Dry-lay and check the manufacturer's instructions before cutting or ordering.

Download SVG plan